|
|
The SatLink 100 is a DVB-S2 plug-in card, allowing DVB-S2 field upgrades of the older SatLink 19xx VSAT IDUs. Current SatLink 1910 VSAT IDUs include DVB-S2 support on the mother board, so this plug-in is not required on those units. See datasheet below.
|
Specifications :
|
|
Demodulation
|
|
DVB-S
DVB-S2
Roll-Off Factors
Symbol Rates |
QPSK
QPSK, 8PSK
Constant Coding & Modulation (CCM)20%, 25%, 35%DVB-S: 2-45 Msps
DVB-S2, QPSK: 2-36 Msps |
FEC Decoding
|
|
DVB-S
DVB-S2
|
Reed-Solomon + Convolutional Rate 1/2, 2/3, 3/4, 5/6, 7/8
LDPC + BCH: Rates 1/2, 3/5, 2/4, 3/4, 4/5, 5/6, 8/9, 9/10 as per DVB-S2 standard |
LNB Interface
|
|
Connector Type
Signals on LNB Cable
RX Input Signal Level
RX Input Frequency Range
Control Channel RX
RX Power Supply
Cable Length, max
Supported LNBs |
F-type, 75 Ω, female
RX data, 18V DC, control channel
-65 dBm to -20 dBm
950-2150 MHz
0/22 kHz signalling
18V, 300mA max, short circuit protected
Up to 160m using appropriate low loss cable
All LNBs compatible with SatLink 1910 terminal |
Compliance
|
|
| CE |
Fully compliant with R&TTE directive |
Physical/Environmental
|
|
Operating Temperature
Storage Temperature
Humidity
Size |
0 to +45° C
-20 to +85° C
20% to 90%, non-condensing
Approx. 70 x 85 mm
|
|
|
|
